+48 500 409 109

Plastic or metal soffits: how to compare the materials

When comparing PVC and metal soffits, first check whether the eaves allow air to dry the roof. Both materials require profiles and installation clearances, and plastic changes dimensions with temperature. Before installation, inspect the timber, the junction with the façade and how the underlay is led out, as later access will be harder. In the estimate, separate panel area from the length of edge components to compare offers without omitting details. Remember that a soffit does not replace proper metal flashing.

2026-11-14T22:29:04+01:00
Read More

Metal soffits: choosing a profile and keeping the eaves ventilated

Metal soffit cladding should shield the underside of the eaves while leaving open the air path intended for the particular roof assembly. Before choosing a profile, perforation and substructure, check the eaves detail: what lies above the soffit, whether a further connection to the ventilation duct exists, and whether the edges will be properly closed. Covering the entire space with tight metal alone can worsen ventilation despite an aesthetically pleasing result. The choice of profile, including T18 or T35, requires confirming suitability for the specific assembly rather than automatically replacing a low soffit profile.

2026-11-14T22:27:02+01:00
Read More

How can T8 trapezoidal steel sheet be used on façades, soffits and light cladding?

T8 is a sheet with a low profile, usually associated with façades, soffits and cladding. It gives a subtle surface texture. However, it should not be selected on appearance alone. Thickness, coverage and support are important. On a small wall, it is worth planning the divisions at windows and the width of the edge sections in advance. The number refers to a profile height of approximately 8 mm. It does not describe the thickness of the steel core. An example variant has an overall width of 1220 mm and an effective width of 1156 mm. Other products with a similar name may differ in cross-section and coverage width.

2026-11-14T09:31:35+01:00
Read More
Back to top